Advertisement
On-screen display menu system
The OSD menu consists of two submenus, DEVICE INFO and QUICK
SETUP, that can be accessed using the front panel MENU button. View the
menu on a display connected to the HDMI output connector (see figure 1,
E
on page 1). The DEVICE INFO submenu is view only. The following
fields can be configured from the Setup submenu:
•
Output Rate — Select from a list of refresh rates (see
Resolution table
on page 6). The default setting is 1080p @
60 Hz.
HDMI Format — Select the output format:
•
•
Auto (default)
•
DVI RGB 444
•
HDMI RGB 444 Full
HDMI RGB 444 Limited
•
•
HDMI YUV 444 Full
•
HDMI YUV 444 Limited
•
HDMI YUV 422 Full
•
HDMI YUV 422 Limited
Test Pattern — Select an available test pattern to display or to turn a test pattern off. The available test pattern selections are
•
Crop, Alternating Pixels, Crosshatch, Color Bars, and 32 Level Grayscale. The default setting is Off.
•
Factory Reset — Reset the unit to its factory default values (removing any user-specified values) while retaining all TCP/IP
settings.
To adjust settings:
1.
Press the MENU button to access the main menu.
2.
Press the directional arrows to navigate to a desired submenu.
3.
Press the ENTER button to access submenu items of a selected submenu.
4.
Press the directional arrows to navigate a desired submenu item.
5.
Press the ENTER button to select a submenu item for adjustment.
6.
As required, press the directional arrows or press the ENTER button to adjust submenu items.
7.
Press the MENU button to return to the list of submenus or exit the OSD menu.
Product Configuration Software
The FOX3 scaling receiver can be configured by the Product Configuration Software when it is installed on a connected host
device, such as a PC, through the front panel USB port or LAN port (see the FOX3 SR 301/311 User Guide for more details).
NOTE:
A user must have an Insider Account to download and use Product Configuration Software. Contact an Extron
support representative, if you do not already have an Insider Account.
Internal Web Pages
To configure the FOX3 SR 301 using the factory-installed internal web pages in a web browser, connect the LAN port on the
receiver to a LAN or WAN. The default IP address is 192.168.254.254.
NOTE:
Compatible web browsers are Microsoft
Basic scaler SIS commands
Use Simple Instruction Set (SIS) commands for operation and configuration of the scaling receiver. Run these commands from a
PC connected to:
•
A LAN or WAN using the rear panel RJ-45 LAN connector (see figure 1,
The Remote RS-232 port (see figure 1,
•
•
The front panel USB config port (see figure 6,
22023.
NOTE:
The table below is a partial list of SIS commands. For a complete listing of commands and instructions to install an
SSH client, see the FOX3 SR 301/311 User Guide.
Output
®
Edge
®
, Modzilla
®
Firefox
G
) via DataViewer.
on page 3) via an SSH client using IP address 203.0.113.22 and port
B
®
, Google Chrome™, and Apple
I
) via an SSH client and port 22023.
®
Safari
®
.
5
Advertisement
