Nortel Communication Server 1000 Manual page 64

64 Isolate and correct faults
Command
ERRL L <CLR>
ENLL L <FDL>
DISL MPH L <REM>
ENLL MPH L <FDL>
STAT L
STAT MPH L
IDC L
DISL L
ENLL L
DSXP X
ENXP X
DISC l s c
ENLC l s c
DISU l s c u
ENLU l s c u
ENLC l s c
XCON
MISP and SILC/UILC message monitoring commands
Link Diagnostic Program LD 48 is used to monitor and print messages sent
and received by the MISP, SILC, and UILC cards.
These commands are used to enable the technician to monitor ISDN
BRI activity during normal system operation and to facilitate system
maintenance.
Copyright © 2003-2007, Nortel Networks
.
Description
Upload error logs for the MPH application on loop L; if
entered, the <CLR> option clears all error log peg counts.
Enables the MISP.
Disables MPH application on loop l.
Enables MPH application on loop l.
Displays the status of MISP on loop l.
Displays status of MPH application.
Displays MISP basecode and application version number.
Disables network loop l on which MCU and
B-channel/D-channel terminals are defined.
Enables network loop l on which MCU and
B-channel/D-channel terminals are defined.
Disables network card X on which MCU and
B-channel/D-channel terminals are defined.
Enables network card X on which MCU and
B-channel/D-channel terminals are defined.
Disables line cards on which MCU and B-channel/D-channel
terminals are defined.
Enables line cards on which MCU and B-channel/D-channel
terminals are defined.
Disables the unit on which MCU and B-channel/D-channel
terminals are defined.
Enables the unit on which MCU and B-channel/D-channel
terminals are defined.
Enables the line card on which the MCU is defined.
Invoke MPH link interface loopback test 9.
Nortel Communication Server 1000
ISDN Basic Rate Interface Maintenance
NN43001-718 01.01 Standard
Release 5.0 30 May 2007
LD
32
32
32
32
32
32
32
32
32
32
32
32
32
32
32
32
45
Nortel Networks Confidential