Software Configuration - Polycom iPower 600 Installation Instructions Manual

conference using ISDN.
7. Click OK.
8. Configure PathNavigator for Conference on Demand. For details, see the
PathNavigator documentation.
Placing a call using PathNavigator Conference on Demand
To place a call using PathNavigator Conference on Demand, do the
following:
1. From the iPower collaboration application, click the Make a Call button
and then click Directory.
2. Check the box next to each number that you want to dial.
The numbers appear in the
screen. You can select as many numbers as your bridge supports.
3. Click OK to place the call.
If you are placing a multipoint call and have enabled ISDN Callback, you
receive a message from the system indicating that the current call will
be disconnected. Click
then places calls to all of the designated conference participants
(including yourself). Answer this call to start the multipoint
videoconference.
If you have not enabled ISDN Callback, the call connects as a regular
multipoint call, based on the configuration settings. For more
information, refer to the iPower collaboration application online help.

Software Configuration

If the Port Ranges are set incorrectly, the iPower system will crash. For
information on setting the Port Ranges, start AdminTools and access the
online help topic Configuring the Adaptor/NAT/Port Range.
If QoS is enabled, calls through a D-Link NAT (model DI-704P) may not
work.
If the system is configured with an incorrect NAT address, LAN calls
have no video.
RSVP is not supported on iPower systems using the Windows XP
operating system.
If you have upgraded to iPower version 5.0 software from a previous
release, you must install Microsoft's QoS Packet Scheduler in order for
the iPower system's QoS features to work properly. Note that the QoS
Packet Scheduler has already been installed on systems pre-installed
with version 5.0 or 6.0 software.
To install QoS Packet Scheduler:
1. Click Start and then choose Settings > Network and Dial-up
Connections > Local Area Connection.
2. Click Properties.
Selected names
when you receive this message. The system
OK
field at the bottom of the