A.O. Smith BFC Cyclone Installation, User And Service Manual page 33

4.3.6.2
4.3.6.3
4.3.6.4
0311704_BFC_28-120_III_ENEN_V2.4, 2022-10-17
Week program: setting the switch-off time
1.
Use [ ] and [ ] to set the hours. In the example, this is 12.
Confirm with [ENTER].
The cursor moves to the minute digits, which will blink.
2.
Use [ ] and [ ] to set the minutes. In the example, this is 45.
Confirm with [ENTER].
The cursor moves to the desired water temperature.
Week program: setting the water temperature
1.
Use [ ] and [ ] to set the water temperature. In the example this is 75°C.
Confirm with [ENTER].
The cursor moves to PUMP ON
Week program: setting the program-controlled pump
1.
If required, a pump can be controlled during the period. Use [ ] and [ ] to set
PUMP ON. The pump ensures a regular circulation of hot water in the hot water
pipes. You can skip this step if you there is no pump in your hot water circuit.
Confirm with [ENTER].
The cursor moves to SAVE.
Confirm with [ENTER].
2.
The display shown in the figure will appear.
3.
If you wish, you can use [ ] to scroll to another day, and change more switch-on
(see section 4.3.6.1) and switch-off (see section 4.3.6.2) times.
4. After changing all desired switch-on and switch off times, you can start running the
week program:
Scroll with [ ] to START OPERATION.
Confirm with [ENTER].
33