Replacing The Fuel Filter; Servicing The Transaxle Fluid - Toro Wheel Horse 16-38HXL Operator's Manual

Table of Contents

Advertisement

7. Squeeze the ends of the hose clamp together and slide it
up the fuel line toward the fuel tank (Fig. 28).
Figure 28
1. Hose clamp
2. Fuel line
8. Pull the fuel line off of the filter (Fig. 28) and allow the
gasoline to drain into a gas can or drain pan.
Note: Now is the best time to install a new fuel filter
because the fuel tank is empty.
9. Install the fuel line onto the filter. Slide the hose clamp
close to the filter to secure the fuel line and filter.

Replacing the Fuel Filter

Replace the fuel filter after every 100 operating hours or
yearly, whichever occurs first.
The best time to replace the fuel filter (Fig. 28) is when the
fuel tank is empty. Never install a dirty filter if it is
removed from the fuel line.
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Open the hood.
6. Squeeze the ends of the hose clamps together and slide
them away from the filter (Fig. 28).
7. Remove the filter from the fuel lines.
8. Install a new filter and move the hose clamps close to
the filter.
9. Close the hood.

Servicing the Transaxle Fluid

Check the fluid level after every 100 hours or yearly,
whichever occurs first. Always keep the fluid level at the
full level when the transaxle is cold.
2
1
3
3. Filter
27
Note: The transaxle is factory sealed and does not require
oil changes.
Fluid Type: SAE 20W-50 engine oil (API service SH/CD
recommended)
Checking the Fluid Level
1. Park the tractor on a level surface.
2. Disengage the blades (PTO).
3. Set the parking brake.
4. Stop the engine and wait for all moving parts to stop.
5. Remove the ignition key.
6. Clean around the fill plug (Fig. 29) so that dirt cannot
fall into the reservoir if fluid needs to be added.
1
m-4983
Figure 29
1. Fill plug
7. Remove the fill plug and check the fluid level.
Note: The level should be a maximum of 1-1/4 in. (32 mm)
below the top of the fill port (Fig. 29). Add oil if necessary.
8. Install the fill plug.
1-1/4 in. max.
(32 mm)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wheel horse 71227

Table of Contents