Table of Contents
Advertisement
4. Plug the square end of the included USB cable to the USB port at the rear of the
scanner.
5. Plug the rectangular end of the USB cable to an available USB port on your
computer.
6. If you plan to connect your scanner to a USB hub
connected to the USB port in your computer. Next, connect the scanner to the
USB hub.
S
t
e
p
3
.
I
n
s
t
a
l
S
t
e
p
3
.
I
n
s
t
a
l
1. Switch on the scanner power from the side of the scanner.
2. If the USB components on your computer are functioning correctly, they will
automatically detect the scanner causing the Add New Hardware Wizard or
Found New Hardware Wizard to be launched.
Information
3. For Windows 2000:
a. Click the Next button when the "Add New Hardware Wizard" window is
displayed.
b. Select
"SEARCH
[RECOMMENDED]" and click the Next button.
c. The next window will ask you where to search to find the drive. Select CD-
ROM drive, and deselect Floppy disk drives if it is checked.
d. Insert the Setup/Application CD-ROM, included with your scanner, into your
CD-ROM drive and then click the Next button.
e. Click the Next button in the window that appears.
f.
During the process of the installation, a message "Digital Signature required"
might be prompted. Please ignore it, and click the Yes button to continue the
installation without any misgiving for your scanner functioning. Afterwards,
please skip to Step 6.
4. For Windows XP:
a. Insert the Setup/Application CD-ROM, included with your scanner, into your
CD-ROM drive.
4
The USB hub is not included with the scanner.
l
i
n
g
t
h
e
S
o
f
t
w
l
i
n
g
t
h
e
S
o
f
t
w
If your computer is off when the scanner is connected,
the "Add New Hardware Wizard" message will not be
displayed until the computer is on and Windows starts.
FOR
THE
4
, make sure that the hub is
a
r
e
a
r
e
BEST
DRIVER
10
FOR
YOUR
DEVICE
Advertisement
Table of Contents
