Table of Contents
Advertisement
Adjustment Location / 调整定位
■ Switch / 开关
音量高/低
电源
显示
PF 键
Volume
up/down
Power
Display
PF key
MIC jack
1/2/3/4 keys
1/2/3/4 键
话筒插座
■ Adjustment Point / 调整点
Component Side View / 元件侧视图
•
GND
+B
TX-RX UNIT (X57-630)
Component side
POWER
RXD
CV
TXD
Foil Side View / 锡箔面侧视图
•
ANT
TX-RX UNIT (X57-630)
TC3
Foil side
TC5
BPF
L22
• FUSE
To mount the Fuse, the cable terminal direction must be
as follows.
ADJUSTMENT / 调整
Speaker
扬声器
BPF
AFV
+B GND
TC1
TC2
This side up / 该面向上
cable terminal / 电缆终端
■ Note / 注释
• EEPROM
The tuning data (Deviation, Squelch, etc.) for the
EEPROM, is stored in memory. When parts are changed,
readjust the transceiver.
• EEPROM
EEPROM的调谐数据(偏差，静噪等等)被储存在存储器中。
当零件被改变时，调整通信机。
• AF PA IC (IC102)
How to mounting the IC102.
• AF PA IC (IC102)
IC 102 安装方法。
Pin1 marker
TX-RX UNIT (X57-630)
Component side
Part name label face down. / 部件名称标签向下。
• SPEAKER CABLE
The speaker cable should be formed before mounting the
shield cover as below.
• 扬声器电缆
安装屏蔽罩前，按如下所示整理扬声器电缆。
• 熔丝
安装熔丝，电缆端子方向必须为如下所示。
Fuse / 熔丝
cable terminal / 电缆终端
TK-8108
Speaker
cable
Locator
This side up / 该面向上
41
Advertisement
Table of Contents
