Volvo XC90 Recharge Owner's Manual page 530

STARTING AND DRIVING
Programming HomeLink
Follow these instructions to program
®
HomeLink , reset all programming or repro-
gram individual buttons.
NOTE
In certain vehicles the ignition must be
switched on or in "accessory position"
®
before HomeLink can be programmed or
used. If possible, fit new batteries in the
remote control that shall be replaced by
®
HomeLink for faster programming and
improved transmission of the radio signal.
®
The HomeLink buttons should be reset
before programming.
WARNING
While programming HomeLink
garage door or gate being programmed
may activate. For this reason, make sure
that nobody is in the vicinity of the door or
gate while programming is in progress. The
car should be outside the garage while a
garage door opener is being programmed.
21 Applies to certain markets.
528
®
21
1. Aim the remote control towards the
*
HomeLink
hold it approx. 2-8 cm (approx. 1-3 inches)
from the button. Do not obstruct the indi-
cator lamp on HomeLink
Note: The ability of some remote controls
to program HomeLink
distance of approx. 15-20 cm (approx.
6-12 inches). Bear this in mind if problems
occur with the programming.
2. Press and hold depressed both the button
on the remote control and the button to be
reprogrammed on HomeLink
®
, the
®
button to be programmed and
®
.
®
is improved at a
®
.
3. Do not release the buttons until the indica-
tor lamp has switched from flashing
slowly (approx. once per second) to either
flashing quickly (approx. 10 times per sec-
ond) or illuminating with a constant glow.
> If the indicator lamp illuminates with
a constant glow: Indication that the
programming has finished. Press the
programmed button twice to activate.
If the indicator lamp flashes quickly:
The device to be programmed to
®
HomeLink may have a security func-
tion that requires extra steps. Test by
pressing the programmed button twice
to see whether the programming is
working. Otherwise, continue with the
following steps.
* Option/accessory.