Setting Up The Enclosure And Installing A Drive - IBM 4 U Installation Manual

Setting up the enclosure and installing a drive

You can install up to four full-high drives or six half-high drives in the enclosure; any
combination of drives up to a maximum of six can be installed (for example, you
can install two full-high drives and four half-high drives). Any combination of SCSI,
SAS, and SATA drives can be installed.
Notes:
1. You can use the SAS accessory kit to install either a SAS drive or a SATA drive
2. You can use the USB accessory kit to install either a USB drive or a SATA drive
3. You need an accessory kit for each tape drive that you install in the enclosure.
To set up the tape enclosure and install a drive, complete the following steps.
Note: You will need a flat-blade screwdriver and a Phillips screwdriver during the
installation.
10
IBM 4 U Rack Mount Tape Enclosure: Installation Guide
in the tape drive enclosure.
in the tape drive enclosure.
1.
Review the information in "Safety" on page iii, "Installation guidelines for
rack-mount enclosures" on page 9, and the safety documentation that comes
with your rack cabinet.
2.
Loosen the six screws on the top of the enclosure; then, remove the cover
from the enclosure.