Foxconn 650M02 Series Manual page 51

IRQ [3-7,9-15], NMI (Default: Enabled)
This option is used to enable or disable IRQ[3-7,9-15], NMI.
IRQ 8 Break Suspend (Default: Disabled)
This option is used to enable or disable IRQ8 break suspend.
RING Power Up Control (Default: Enabled)
If this option is enable, it allows the system to resume from a software power
down or power saving mode whenever there is an incoming call to an in-
stalled fax/modem. This function needs to be supported by the relevant hard-
ware and software. The setting values are Disabled and Enabled.
MACPME Power Up Control (Default: Enabled)
This option is used to enable or disable the system to be waken up by onboard
LAN.
PCIPME Power Up Control (Default: Enabled)
This option is used to enable or disable the system to be waken up by PCI
card.
PS2KB Wakeup from S3 (Default: Any key) (optional)
This option used to set which action will wake up PS/2 keyboard from S3
status. The setting values are Any Key, Hot Key, Password.
PS2MS Wakeup from S3 (Default: Move & Click) (optional)
This option used to set which action will wake up PS/2 mouse from S3 status.
The setting values are Disabled, Click, Move & Click.
Power UP by Alarm (Default: Disabled)
This option is used to set the timing of the start-up function. In order to use this
function, the start-up password function must be canceled. Also, the PC power
source must not be turned off. The setting values are Disabled and Enabled.
650M02 and 651M02 Series User Manual
Chapter 3
PM Wake UP Events Menu
BIOS Description
51