Connect The Telephone Cord - Uniden XDECT 8315 Series Owner's Manual

Connect the Telephone Cord

Use the telephone cord to connect the TEL LINE jack to a standard
telephone wall jack.
Test the Connection
1) Pick up the handset from the cradle and press HOME/FLASH. You
should hear a dial tone, and the display should say Talk.
If...
you don't hear a dial
tone or the display
says Check Tel Line
2) Make a quick test call. (Press END/CLEAR to hang up.)
If...
there's a lot of
noise or static
3) Test any accessory handsets the same way. If you can't get a dial
tone or the handset display says Unavailable, try moving the handset
closer to the base or resetting it (see page 36). Charge all handsets
completely (about 15-20 hours) before using them.
Installing the Belt Clip
Line up the holes on each side of the handset. To attach the belt clip, insert
into the holes on each side of the handset. Press down until it clicks. To
remove the belt clips, pull either side of the belt clip to release the tabs
from the holes.
Try...
checking the connection between the
base and the phone jack.
Try...
see page 33 for tips on avoiding
interference.
7