Table of Contents
Advertisement
REMOTE READY MODELS
OPERATION
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don't try to repair it, call a quali-
fied service technician or gas supplier.
Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
900463-01C
OPERATION
• If fireplace has glass doors, never
operate this appliance with glass
doors closed. If you operate ap-
pliance with doors closed, heat
buildup inside fireplace will cause
glass to burst. Make sure there are
no obstructions across openings
of fireplace.
• You must operate this appliance
with a fireplace screen in place.
Make sure fireplace screen is
closed before running appliance.
NOTICE: During initial operation
of new appliance, burning logs
will give off a paper-burning smell.
Orange flame will also be present.
Open damper or window to vent
smell. This will only last a few hours.
NOTE: Homeowners generally prefer to operate
their appliance with the chimney damper closed.
This will put all the heat into the room. However,
there may be times you will desire the full flames
of the HI heat setting but will find the heat output
excessive. You can open the chimney damper (if
you have one) fully or partially to release some
of the heat.
will be hot if appliance has been
running.
1. STOP! Read the safety information, col-
2. Make sure equipment shutoff valve is fully
3. Set switch to OFF position.
4. Press in and turn control knob clockwise
5. Wait five (5) minutes to clear out any gas.
SuperiorFireplaces.us.com
LIGHTING
INSTRUCTIONS
WARNING:
WARNING: Damper handle
umn 1.
open.
to the OFF position (see Figure
35, Page 24).
Then smell for gas, including near the
floor. If you smell gas, STOP! Follow "B"
in the safety information, column 1. If you
don't smell gas, go to the next step.
23
Advertisement
Table of Contents
