Table of Contents
Advertisement
8
Troubleshooting
Problem
Drying process
takes too long.
Dryer does not
switch on or the
program does not
start. Dryer does
not start when set.
Program is
interrupted for no
reason.
Laundry has
shrunk, become
felted or has
deteriorated.
"End / Anticrease"
LED flashes.
"End / Anticrease"
LED is on.
"Filter cleaning"
LED flashes.
The "Drying" LED
flashes.
NOTE: Call an authorized service if the problem persists.
Dryer / User Manual
Cause
*Lint filter may not have been
cleaned.
*Ventilation grids on the front side of
the machine are blocked.
*Ventilation is not sufficient since the
room where the machine is installed
is very small.
*Lime deposit has built up on the
dampness sensor
*Excessive laundry is loaded.
*Laundry is not spun sufficiently
* It may not plugged in.
* The loading door may be ajar.
* Program may not be set or the
"Start/Pause/Cancel" button may
not have been pressed.
* "Childproof lock" may be activated.
* The loading door may be ajar.
* Electricity may be cut off.
* A program not suitable for the
laundry type might have been used.
* The 2-hour anti creasing program
to prevent laundry from wrinkling
may have been activated.
* Program has come to an end.
* Lint filter may not have been
cleaned.
* A heat sensor failure has occurred.
dryer ends the program without
heating.
Explanation / Solution
* Clean the lint filter.
* Meshes of the filter may be
clogged. Wash with water.
*Remove the objects (if any) that
block ventilation in front of the
ventilation grids.
*Open the door and window of the
room to avoid the room temperature
increase too much.
*Clean the dampness sensor.
*Do not load the dryer in excess.
*Spin your laundry at a higher speed
in your washing machine.
* Make sure that the dryer is
plugged in.
* Make sure the loading door is
properly closed.
* Make sure the program has been
set and it is not in "Pause" mode.
* Deactivate the childproof lock.
* Make sure the loading door is
properly closed.
* Press the "Start/Pause/Cancel"
button to start the program.
* Dry only the laundry which is
suitable for drying in the dryer. First
check the labels on the clothes.
* Select a program a suitable low
temperature setting for the laundry
type to dry the clothes.
* Turn off the dryer and take the
laundry out of the dryer.
* Turn off the dryerand take the
laundry out of the dryer.
* Clean the lint filter.
* Meshes of the filter may be
clogged. Wash with water.
* Turn off the dryer and remove the
laundry. Call the authorized service.
23 / EN
Advertisement
Table of Contents
