Product Use - Planar SD2620W User Manual

Product Use

Operating in 2D mode
Your SD2620W unit can operate
either as a 3D stereoscopic monitor or in
the standard 2D mode. Converting to 2D
viewing can be accomplished by either
turning off the power to one of the
monitors or by putting the mirror into
the locked upright position. To move
the mirror to the raised position, use two
hands to slide it up the mirror support
arms and then raise it until it drops into
the locked position. To lower the mirror,
use two hands to lift it out of the locked
slot and then lower it down onto the fine
adjustment screws.
The mirror should not be forced down. This can break the glass
and damage the mirror frame. The mirror must be pulled forward
before lowering.
User controls and OSD menu
The two monitors have a power switch on the right side of the bottom bezel
and a power toggle switch on the back. The LED indicator next to the Power
button shows the monitor power status. When the LED is green, the power
is on. When the LED is amber, the monitor is in power-saving mode. The
monitor is off when the LED indicator is dark.
Controls and LED indicator
StereoMirror in 2D mode
User's Guide | 9