GE Profile PFQ97HS Owner's Manual And Installation Instructions page 5

Getting started
Display and Status Lights
(Features and appearance will vary)
The display shows the cycle options selected, the approximate time remaining until the end of the cycle and the cycle
status for WASH and DRY modes (PreWashing, Washing, Rinsing, Spinning, Drying, Complete).
NOTE: The cycle time is affected by how long it takes the Combo to fill, based on the water pressure in your home.
Cycle time is also adjusted based on potential rebalances which may be required to thoroughly spin out the wet load.
And finally, for cycles with DRY added, the Combo will adjust the drying time to achieve the desired final moisture
content.
If an out-of-balance condition is detected by the Combo, the Spin status light or Spin option selection light will blink
during the remaining portion of the cycle and will stay illuminated for a short time after cycle completion. When this
occurs, the Combo is taking actions to correct the out-of-balance condition and complete the cycle normally. In some
cases, the Combo may not be able to balance the load and spin up to full speed. If you notice the load is more wet
than usual at the end of the wash portion of the cycle, redistribute the load evenly in the wash basket and run a
Rinse & Dry cycle.
The LIGHT RING will show a single LED next to the cycle you have selected until you start the cycle. It will then
show a representative countdown of the total cycle with the left half in blue tracing the wash cycle and the right
half in magenta tracing the dry cycle. In addition, the LIGHT RING may indicate actions to remind you to perform
maintenance, show signal cycle completion, WiFi set-up or warning messages.
In addition, the display will show:
Will allow your appliance to communicate with your smartphone for remote appliance monitoring,
(WiFi)
control and notifications. It stays lit whenever the Combo is on and is connected.
The controls on the Combo are locked when this icon is illuminated. You must press and hold
the Control Lock button to unlock the controls.
This icon will illuminate while the door is locked and will blink while the Combo is in the process
of pausing and then unlocking.
This icon indicates that you are using your MySettings options for the cycle selected. MySettings
for a cycle can be set by choosing a cycle, selecting your preferred options and then pressing
and holding the cycle name again. In the future, simply select that cycle and your MySettings
will be instantly recalled. If the heart icon has the letters "AI" inside (
has automatically programmed the MySettings for that particular cycle based on your frequently
chosen options.
Detergent will automatically dose from the SmartDispense - Detergent dispenser according to the
weight and soil level of the clothes and brand of product selected. You can adjust this feature to dose
MORE or LESS detergent or turn it OFF to manually dose.
Fabric softener will automatically dose from the SmartDispense - Softener dispenser according
to the weight of the clothes and brand of product selected. You can adjust this feature to dose
MORE or LESS fabric softener or turn it OFF to manually dose.
49-3000353 Rev 3
), that means the Combo
5