GE Profile PFQ97HS Owner's Manual And Installation Instructions page 24

UNPACKING THE COMBO
Recycle or destroy the carton and
WARNING
plastic bags after the Combo is
unpacked. Make materials inaccessible to children.
Children might use them for play. Cartons covered
with rugs, bedspreads or plastic sheets can become
airtight chambers causing suffocation.
1. Cut and remove all packaging straps.
2. While it is in the carton, carefully lay the Combo on its
side. DO NOT lay the Combo on its front or back.
3. Turn down the bottom flaps. Remove all base packaging
including the styrofoam base.
4. Carefully return the Combo to an upright position and
remove the carton by lifting it upward.
5. Carefully move the Combo to within 4 feet (122 cm)
of the final location.
6. Remove the following from the back side of the Combo:
4 bolts
4 plastic spacers (including power cord retainers and
rubber grommets)
2 brackets and the screws fastening them to the Combo
NOTE: Do NOT remove the screw or clip holding the
hose.
Spacer
Bolt
Retainer
Bracket
24
Installation Instructions
UNPACKING THE COMBO (cont.)
Watch this video for more step by
step instructions on the importance
of removing the shipping bolts before
operating your Combo.
7. Insert shipping bolt hole covers into shipping bolt
holes.
IMPORTANT:
• Failure to remove all shipping support hardware can
cause the Combo to become severely unbalanced.
• Save all shipping support hardware for future use.
If you must transport the Combo at a later date,
you must reinstall the shipping bolts and spacers
to prevent shipping damage. The brackets are not
required and can be discarded.
NOTE: Consider recycling options for your appliance
packaging material.
49-3000353 Rev 3