Touch Screen Driver Installation; Driver Installation Process; Pt1945R Driver Install Instructions; Pt1945R Calibration Tool Install - Planar PT1945R User Manual

Touch Screen Driver Installation

Driver Installation Process:

1. Before you start to install the touch driver, please be sure the USB or the RS-232 Serial
cable is connected from the PC to the LCD display.
2. Uninstall any touch screen driver that may be on your system.
3. Click on the driver link found on the CD-ROM.
4. Follow instructions as found below and on the CD-ROM.
5. After installation is complete, click "Finish" and restart your computer to complete
installation.

PT1945R Driver Install Instructions:

The PT1945R is available with both RS232 and USB connections. It is Microsoft® Windows®
HID (Human Interface Device) compatible if you use the USB touch screen interface. No
additional software driver is required for general operation of the touch screen. A calibration
tool can be installed for improved touch position accuracy. See "Optional Calibration Tool
Install" section for more information.
The touch driver is located on the enclosed CD-ROM for these operating systems:
Windows® 7, VISTA, XP, 2000, ME, 98, NT4.0, CE, XP Embedded, Linux, Apple® Mac OS.
Please note: Do not plug in both RS232 and USB cables. Doing so may cause a driver
confl ict, making your touch screen idle.

PT1945R Calibration Tool Install:

If you would like to use the Optional Calibration Tool, follow the instructions below. Please
note: the calibration tool supports Windows® 7, VISTA, XP, XP Embedded, 2000 and ME
operating systems via USB only.
1. Open the CD-ROM.
2. Select the monitor size and then model name
3. Click on the "Load Utility" button that appears to the right of the model name.
4. The HID calibration tool will automatically open. From here the user can choose to do
the following:
a. 4 Points Calibration
b. 9 Points Linearization
c. 25 Points Linearization
d. Clear
e. Draw Test
f. Advanced. In the Advanced settings area the user may do the following:
i. Adjust the Double Click Area
ii. Enable auto right click and adjust the auto right click time
iii. Choose to be either in the HID Mouse Mode or HID Digitizer Mode (Windows®
Vista only)
iv. Simply click the "Apply" button once the settings are fi nalized.
17