Table of Contents
Advertisement
User's Manual of UPOE-800G/UPOE-1600G/UPOE-2400G
2.2.3 Network Application Installation
The 802.3bt PoE++ Managed Injector Hub is not an equipment with data switching function between data ports. To inject
PoE power and transmit data packets to PDs, the 802.3bt PoE++ Managed Injector Hub is usually linked to an Ethernet
switch. Typically, the Ultra PoE Injector is installed between regular Ethernet switch and PDs, and mostly it is located close
to the Ethernet switch side.
To install an 802.3bt PoE++ Managed Injector Hub on a network environment, simply complete the following steps:
Step 1: Power on the 802.3bt PoE++ Managed Injector Hub and connect the RJ45 cable from the "Data" port to the
Ethernet switch port.
Step 2: Connect the RJ45 cable from the "Data + Power" ports to the PDs, such as VoIP phone and IP camera.
Step 3: Check the link status on both PD and Ethernet switch. Once the Injector starts to deliver 54V power over RJ45
cables to PDs, the PoE-in-Use LED of the 802.3bt PoE++ Managed Injector Hub will light up.
Figure 2-2-4: Network application installation
The 802.3bt PoE++ Managed Injector Hub supports data passive mode, that is, even the 802.3bt PoE++ Managed
Injector Hub is manually powered off. The data between "DATA" port and "DATA & PWR" port can still be transmitted
without data loss.
25
Advertisement
Table of Contents
