D-Link DMS-3130 Series Hardware Installation Manual page 2

DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
Information in this document is subject to change without notice. Reproduction in any manner whatsoever, without the written
permission of D-Link Corporation, is strictly forbidden.
Trademarks used in this text: D-Link and the D-LINK logo are trademarks of D-Link Corporation; Microsoft and Windows are
registered trademarks of Microsoft Corporation.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or
their products. D-Link Corporation disclaims any proprietary interest in trademarks and trade names other than its own.
© 2022 D-Link Corporation. All rights reserved.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at his expense.
CE Mark Warning
This equipment is compliant with Class A of CISPR 32. In a residential environment this equipment may cause radio interference.
VCCI Warning
この装置は、クラス A 情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすことがあります。この場合には
使用者が適切な対策を講ずるよう要求されることがあります。VCCI-A.
BSMI Notice
此為甲類資訊技術設備，於居住環境中使用時，可能會造成射頻擾動，在此種情況下，使用者會被要求採取某些適當的對策。
Safety Compliance
Warning: Class 1 Laser Product:
Product shall be used with Class 1 laser device modules certified by CDRH.
Le produit peut être utilisé avec des modules de dispositifs laser de classe 1 certifiés par le CDRH.
EN: When using a fiber optic media expansion module, never look at the transmit laser while it is powered on. Also, never
•
look directly at the fiber TX port and fiber cable ends when they are powered on.
FR: Ne regardez jamais le laser tant qu'il est sous tension. Ne regardez jamais directement le port TX (Tramsmission) à
•
fibres optiques et les embouts de câbles à fibres optiques tant qu'ils sont sous tension.
SFP (Mini-GBIC), XENPAK, and XFP Regulatory Compliance
Networks pluggable optical modules should meet the following regulatory requirements:
Class 1.
•
IEC/EN60825-1:2007 2nd Edition or later, European Standard
•
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA and CDRH requirements.
•
Application of CE Mark in accordance with 2004/108/EEC EMC Directive and the 2006/95/EC Low Voltage Directives.
•
• UL and/or CSA registered component for North America.
47 CFR Part 15, Class A when installed into products.
•
Warning
Class I Equipment. This equipment must be earthed. The power plug must be connected to a properly wired earth ground socket
outlet. An improperly wired socket outlet could place hazardous voltages on accessible metal parts.
Avertissement
Équipement de classe I. Ce matériel doit être relié à la terre. La fiche d'alimentation doit être raccordée à une prise de terre
correctement câblée. Une prise de courant mal câblée pourrait induire des tensions dangereuses sur des parties métalliques
accessibles.
ii