Power Supply - Siemens SIMATIC NET SCALANCE W734-1 Operating Instructions Manual

5.2

Power supply

Note
Galvanic isolation of the power supply unit
To ensure dielectric strength according to IEEE 802.3, the supplying 24 V power supply unit
must be galvanically isolated with a dielectric strength of 1500 VAC. The galvanic isolation
must also not be bridged by other devices connected to the same power supply unit.
SCALANCE W774/W734 RJ-45
For the power supply, there are two options with the SCALANCE W774/W734:
● Direct feed in via the four-pin socket (position
For the direct feed-in power supply use copper cables with the following properties:
– Round cable cross-section with 6 to 8 mm diameter.
– Two-wire cable with 0.5 to 1.5 mm2 cross-section per wire.
– Permitted tensile load at least 100 N. - UL
– Listing of the cables according to the national installation regulations. In areas where
● Power over Ethernet via the RJ-45 Ethernet interface P2 (position
interface P1 is not capable of PoE.
The four-pin connecting socket has the following pin assignment:
Pin
L1+
M1
M2
L2+
SCALANCE W774-1 /W734-1
Operating Instructions, 09/2017, C79000-G8976-C325-09
NEC or CEC applies: Type PTLC or ITC
P o E
L A N
P 2
L A N
P 1
L 2 +
M 2
M 1
L 1 +
L1+ M1 M2 L2+
①
)
②
Assignment
24 VDC
Ground
Ground
24 VDC
Connection
5.2 Power supply
). The other Ethernet
39