Table of Contents
Advertisement
B-1
SAFETY PRECAUTIONS
Do not attempt to use this equipment until you
have thoroughly read the engine manufacturerʼs
manual supplied with your welder. It includes
important safety precautions, detailed engine
starting, operating and maintenance instructions,
and parts lists.
------------------------------------------------------------------------
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or
electrode with skin or wet clothing.
• Insulate yourself from work and
ground
• Always wear dry insulating gloves.
• Always operate the welder with the hinged door
closed and the side panels in place.
• Read carefully the Safety Precautions page
before operating this machine. Always follow
these and any other safety procedures included
in this manual and in the Engine Instruction
Manual.
------------------------------------------------------------------------
GENERAL DESCRIPTION
The EAGLE™ 10,000 Plus is a twin-cylinder, gasoline
driven, multiprocess arc welder and AC power gener-
ator. It is built in a heavy gauge steel case for durabili-
ty on the job site.
Codes 11791 and above meet EPA evaporative emis-
sion requirements.
OPERATION
WELDER CONTROLS - FUNCTION AND
OPERATION
ENGINE SWITCH
The engine switch is used to Start the Engine, Select
High Idle or Auto Idle while the engine is running, and
stop the Engine.
When placed in the "OFF"
circuit is de-energized to shut down the engine.
When held in the "START"
starter motor is energized.
When in "HIGH IDLE" (
run continuously at high idle.
When in "AUTO IDLE" (
engine will run continuously and the idler operates as
follows:
• Welding
When the electrode touches the work, the weld-
ing Arc is initiated and the engine accelerates to
full Speed.
After welding ceases (and no auxiliary power is
being drawn), the engine will return to low idle
after approximately 10 to 14 seconds.
• Auxiliary Power
With the engine running at low idle and auxiliary
power for lights or tools are drawn (approximate-
ly 100-150 watts or greater) from the recepta-
cles, the engine will accelerate to high speed. If
no power is being drawn from the receptacles
(and not welding) for 10-14 seconds, the idler
reduces the engine speed to low idle.
EAGLE™ 10,000 PLUS
B-1
position, the ignition
position, the engine
) position, the engine will
/
) position, the
Advertisement
Table of Contents
