Honda CB1100CA 2017 Owner's Manual page 72

Engine Oil Changing Engine Oil & Filter
u
Remove the oil filter with a filter wrench
6.
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
Discard the oil and oil filter at an
u
approved recycling centre.
Oil filter
Apply a thin coat of engine oil to the
7.
rubber seal of a new oil filter.
68
8.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft)
9.
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Rubber seal 10.
Required oil
11.
12.
Install the new oil filter and tighten.
Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Fill the crankcase with the recommended
oil ( P. 50, P. 126) and install the oil fill
2 2
cap.
When changing oil & engine oil filter:
3.9 L (4.1 US qt, 3.4 Imp qt)
When changing oil only:
3.8 L (4.0 US qt, 3.3 Imp qt)
Check the oil level. P. 65
2
Check that there are no oil leaks.