Honda CB1100CA 2017 Owner's Manual page 104

Tyre Puncture
u
Take care to prevent the brake caliper
u
from scratching the wheel during
installation.
Use new mounting bolts when
u
installing the brake caliper.
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Lower the front wheel on the ground.
9.
Apply the brake lever several times. Then,
10.
pump the fork several times.
Retighten the left axle pinch bolts.
11.
Torque:
CB1100CA
26 N·m (2.7 kgf·m, 19 lbf·ft).
CB1100NA
22 N·m (2.2 kgf·m, 16 lbf·ft).
100
Removing Wheels
Raise the front wheel off the ground
12.
again, and check that the wheel rotates
freely after you release the brake.
Uncover the protective tape or cloth.
13.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.