Table of Contents
Advertisement
Partially install two light kit screws,
found in the
hardware bag, through
the gasket halfway into the motor
housing as shown. It does not matter
which two screw holes you choose.
Lift the LED assembly and connect the
single-pin connectors to the connectors from
the fan. Connect the white wires together.
Connect the blue and black wires together.
Note:
Fan style may vary.
Ceiling Bracket
Downrod
Assembling the Light
2 of 6
Light Kit Screw
bag
Feed the wire plugs
through the center hole of
the upper switch housing,
then wrap keyhole slots
around the screws and twist
counterclockwise.
Align the holes of LED assembly with
the holes of the upper switch housing.
Make sure all the wires from the fan
and the light kit are snug inside the
center of the light kit, not pinched in
between the upper switch housing and
the light kit or hanging out of the sides.
Installing the Bulbs and Glass
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan
Wiring
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Note:
Fan style may vary.
Canopy
Blades
bag
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
bag
Insert the light kit screws, found in the
hardware bag. Tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light
Glass
1886
1 of 6
Light Kit Screw
3 of 6
Light Kit Screw
ON
8
Control
Advertisement
Table of Contents
