Hanging The Fan - Hunter Skysail Installation Manual

1886
1886
Follow below if you are using the downrod that came pre-assembled in your box. Need to
install a longer or shorter downrod? Check out the guide at the end of this manual.
Slide the adapter cover onto
the downrod until it rests
against the hanger ball.
Hunter Pro Tip:
The adapter cover is not used for
low-pro le mounting.
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
5
Ceiling Bracket
Installing the Downrod
Back out the pre-installed setscrew
so that the setscrew's threads
are still engaged while the shank
does not protrude and obstruct the
insertion of the downrod.
Downrod Hanging Fan
Wiring the Fan
DO NOT
REMOVE
SETSCREW
COMPLETELY
Lower the adapter cover until it rests ush
against the motor housing.

Hanging the Fan

Hanging the Fan
Wiring Canopy
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
Pass all wires to one side of horizontal bar in
downrod assembly. Hand tighten the downrod
(at least 4–5 full turns) until it stops. Trim the
wires coming from the fan so that 8-inches
remain coming from the top of the downrod.
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
Note:
Fan style may vary.
NOTICE NOTICE
To prevent damage to fan, To prevent damage to fan,
ALWAYS lift holding either the ALWAYS lift holding either the
fan housing or the downrod. fan housing or the downrod.
Place the downrod ball into Place the downrod ball into
the slot in the ceiling bracket. the slot in the ceiling bracket.
Blades Light
DR-01 r061622
Glass Control