Table of Contents
Advertisement
SETUP INSTRUCTIONS - STANDARD HITCH
1.
With the mower sitting flat on the ground loosen the fasteners attaching the "A" frame struts to the frame
and rotate up into the vertical position.
2.
After placing the "A" Frame in the vertical position tighten the larger nut just tight enough to allow the
"A" Frame to piviot. Holding the larger nut in position tighten the jam nut (Smaller Nut) against the larger
nut to lock in this position allowing the base frame of the cutter to float when in use.
IMPORTANT: Scan this QR Code with your smart phone to link to the PAMI Safe
Implement Hitching Manual for more information on correctly connecting
agricultural tractors to implements. Or type in your internet browser the following
web address: www.algqr.com/hme
SETUP INSTRUCTIONS - SHIELDING AND DEFLECTORS
The Bush Hog SQ84T as shipped from the factory, have all Shielding and Deflectors in place. Dealer should
inspect to make sure that all Safety Shielding and Deflectors are in place and fasteners are tight.
Front and Rear Deflectors are Standard Equipment. One type of guard must be installed
DANGER
(and maintained in good repair) except for agricultural purposes only in areas where
persons, vehicles, livestock, or other property will not be endangered by thrown objects and
where such safety equipment would prevent the mower's reasonable performance of its
assigned agricultural task.
Deflectors: Front and Rear Deflectors (Standard Equipment) are recommended for the average user and will
provide protection from thrown objects with proper operation under normal conditions. Deflectors must be
maintained in good repair or replaced after no more than two inches of wear off lower edge.
SQ84T 12/21
© 2021 Alamo Group Inc.
ASSEMBLY
Ops-0008-MISC
Assembly Section 3-3
Advertisement
Chapters
Table of Contents
