Operating Instructions - Intex PRISM FRAME 126796GN Manual

OPERATING INSTRUCTIONS

1. Make sure the filter pump is switched off. The switch is located on the motor housing.
2. Connect the filter pump power cord end to the transformer output receptacle and screw in
the cover. Plug the transformer power cord into a properly installed electrical socket.
Risk of electric shock. Connect this product only to a grounding type
receptacle protected by a ground-fault circuit interrupter (GFCI) or
residual current device (RCD). Contact a qualified electrician if you
cannot verify that the receptacle is protected by a GFCI/RCD. Use a
qualified electrician to install the GFCI/RCD, which has a maximum rate
of 30mA. Do not use a portable residual current device (PRCD).
To prevent air lock, open the lower plunger valve (connected inlet hose) first and
then the upper plunger valve (connected outlet hose). Open the air release valve,
wait until water starts to flow out of the air release valve, close air release valve.
3. Turn both plunger valve handles fully counter-clockwise until they stop. This opens the
valve, allowing water to flow into the filter pump.
4. With water flowing into filter pump, the water pressure will allow the air trapped inside to
escape from the air release valve (2). When all the air has escaped water will flow out of the
valve (2). When this occurs gently finger tighten the valve (2) in a clockwise direction.
5. To operate the filter pump on "TIMER" mode:
A. Plug the power cord into the electrical outlet and set the timer dial to the desired
operating hours (see Fig. 10). See the "Operating Time Table" for the required operating
hours related to each pool size.
B. The filter pump is now filtering the water and will stop after the operating hours are
completed. The built-in timer will now operate for the number of hours selected at the
same time each day.
C. Operating hours can be re-adjusted if necessary. Follow step A – B.
To operate the filter pump manually (without the "TIMER" mode):
A. Turn on the pump by setting the dial to "
the water.
B. To turn off the pump, set the dial to "
6. Never put pool chemicals directly into the filter pump. This may damage the pump and void
the warranty.
SAVE THESE INSTRUCTIONS
(108GS) MODEL 636G FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 05/23/2022
WARNING
IMPORTANT
" position, the filter pump is now filtering
" position.
: OFF
: ON (without the Timer)
2 / 4 / 6 / 8 / 12 : Timer operating time (hours)
FIG 10
108
English
GS
Page 10