Operating Instructions - Intex ULTRA XTR 126374GN Manual

OPERATING INSTRUCTIONS

• Risk of electric shock. Connect this product only to a grounding type receptacle protected
by a ground-fault circuit interrupter (GFCI) or residual current device (RCD). Contact a
qualified electrician if you cannot verify that the receptacle is protected by a GFCI/RCD.
Use a qualified electrician to install the GFCI/RCD, which has a maximum rate of 30mA.
• To reduce the risk of electric shock, do not use extension cords, timers, plug adaptors or
converter plugs to connect unit to electric supply; provide a properly located outlet.
• Do not attempt to plug in or unplug this product while standing in water or when your
hands are wet.
• Never operate this product above the maximum working pressure stated on the filter tank.
• Always switch off pump before changing the 6-way valve position.
• Operating this product without water flowing through the system can cause a build up of
hazardous pressure which can result in an explosive situation, serious injury, property
damage or death.
• Never test this pump with compressed air. Never operate the system with water
temperature above 35°C (95°F).
6-way valve positions and function:
Valve Position
Normal filtration and regular vacuuming
FILTER
of pool
(see drawing 23)
Reverses water flow to clean filter
BACKWASH
media
(see drawing 24)
For initial startup cleaning of the sand, and
RINSE
leveling the sand bed after backwashing
(see drawing 25)
For vacuuming directly to waste,
WASTE
lowering pool level or to drain the pool
(see drawing 26)
For circulating water back to pool
RECIRCULATE
without going through the filter media
(see drawing 27)
Shuts off all flow to filter and pool "Do not
CLOSED
use this setting with pump running"
(see drawing 28)
23
Control panel description:
ON / OFF button
LED Reading
00
01
02-11
12
.
FP
SAVE THESE INSTRUCTIONS
(342GS) SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 06/06/2022
WARNING
Function
24 25
LOCK / UNLOCK button
Stand-by mode (start-up / operating cycle finished)
Minimum operating hour (1 hour remaining)
Operating hours (2 - 11 hours remaining)
Maximum operating hours (12 hours remaining)
Timer OFF (pump operating continuously)
Power saving mode
Water Flow Direction
From pump through filter media to
pool
From pump through filter media to
valve waste/drain outlet
From pump through filter media to
valve waste/drain outlet
From pump to valve waste/drain
outlet bypassing the filter media
From pump through valve to pool
bypassing the filter media
26 27
TIMER button
Definition
342
English
GS
28
Page 17