Intex PRISM FRAME 126796GN Manual page 41

POOL SETUP ( continued )
6. With one person standing inside the pool, raise one corner;
insert the connecting rod (10) into the overlapping openings,
to connect the liner straps to the restrainer straps. Repeat
the operation in the other corners and then on the sides
(see drawings 6.1 & 6.2).
7. Pull the bottoms of the side supports out away from the
liner to make the straps taut. Repeat for all locations
(see drawing 7).
8. If the ground is not concrete (asphalt, lawn or earth) you
must place a piece of pressure-treated wood, size
15" x 15" x 1.2", under each leg and flush with the ground.
The U-shaped side supports must be placed in the center
of the pressure-treated wood and with the wood grain
perpendicular to the support leg (see drawing 8).
NOTE: Make sure each support pad is recessed and set
flush with the ground and not just placed on the ground.
Do not use support pads or slabs with slippery, smooth
surfaces as the U-shaped side support will slide outward
causing damage to the pool and void the warranty.
9. Assemble the ladder. The ladder has separate assembly instructions in the ladder box.
10. Place the assembled ladder over one of the sides with one of the liner installation team members
entering the pool to smooth out all bottom liner wrinkles. While inside the pool this team member
should check the 2 drain valves (in corners) to be sure the inside drain plug is inserted into the valve.
This team member should push inside corner in an outward direction.
11. Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain
cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch (2.5cm) of water. Check
to see whether the water is level. Also make sure all the corner joints (6) are properly inserted into the
beams before continue filling the pool with water.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting
up the pool on unleveled ground will cause the pool to tilt resulting in the sidewall material to
bulge. If the pool is not completely level, you must drain the pool, level the area and re-fill the
pool.
Smooth out the remaining wrinkles (from inside the pool) by pushing out where the pool floor and pool
sides meet. Or, (from outside pool) reach under the side of the pool, grasp the pool floor and pull it out.
If the ground cloth is causing the wrinkles, have 2 people pull from either side to remove all wrinkles.
SAVE THESE INSTRUCTIONS
(85IO) PRISM FRAME™ OVAL PREMIUM POOL ENGLISH 7.5" X 10.3" PANTONE 295U 04/18/2022
English
LINER
LINER
10
10
Level
Page 10
85
A
6.1
6.2
7
8