Operating Instructions - Intex 126356NP Owner's Manual

OPERATING INSTRUCTIONS

• Risk of electric shock. Connect this product only to a grounding type receptacle protected by a ground-fault
circuit interrupter (GFCI) or residual current device (RCD). Contact a qualified electrician if you cannot verify that
the receptacle is protected by a GFCI/RCD. Use a qualified electrician to install the GFCI/RCD, which has a
maximum rate of 30mA. Do not use a portable residual current device (PRCD).
• To reduce the risk of electric shock, do not use extension cords, timers, plug adaptors or converter plugs to
connect unit to electric supply; provide a properly located outlet.
• Do not attempt to plug in or unplug this product while standing in water or when your hands are wet.
• Never operate this product above the maximum working pressure stated on the filter tank.
• Always switch off pump before changing the 6-way valve position.
• Operating this product without water flowing through the system can cause a build up of hazardous pressure
which can result in an explosive situation, serious injury, property damage or death.
• Never test this pump with compressed air. Never operate the system with water temperature above 35°C (95°F).
6-way valve positions and function:
Valve Position
Normal filtration and regular vacuuming
FILTER
of pool
(see drawing 23)
BACKWASH Reverses water flow to clean filter
(see drawing 24) media
For initial startup cleaning of the sand, and
RINSE
leveling the sand bed after backwashing
(see drawing 25)
For vacuuming directly to waste,
WASTE
lowering pool level or to drain the pool
(see drawing 26)
For circulating water back to pool
RECIRCULATE
without going through the filter media
(see drawing 27)
CLOSED Shuts off all flow to filter and pool
"Do not use this setting with pump running"
(see drawing 28)
23
Control panel description:
ON / OFF button
LED Reading
00
01
02-11
12
.
FP
SAVE THESE INSTRUCTIONS
(341IO) MODEL SF90220-2 SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 05/17/2022
WARNING
Function
24 25
LOCK / UNLOCK button
Stand-by mode (start-up / operating cycle finished)
Minimum operating hour (1 hour remaining)
Operating hours (2 – 11 hours remaining)
Maximum operating hours (12 hours remaining)
Timer OFF (pump operating continuously)
Water Flow Direction
From pump through filter media to
pool
From pump through filter media to
valve waste/drain outlet
From pump through filter media to
valve waste/drain outlet
From pump to valve waste/drain
outlet bypassing the filter media
From pump through valve to
pool bypassing the filter media
26 27
TIMER button
Definition
Power saving mode
341
English
A
28
Page 15