Table of Contents
Advertisement
A-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been configured in Intel RST Premium With Intel Optane System Acceleration
mode, please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure CSM Support under the Boot menu is disabled.
2. Go to Settings\IO Ports\SATA And RST Configuration and make sure USE RST Legacy OROM is disabled
and RST Control PCIe Storage Devices is set to Manual. If you want to enable the Optane
in the M2A connector, set PCIe Storage Device on Port 9 to RST Controlled.
3. Enter the operating system, launch the Intel
then enable Intel
Optane
®
™
4. If you install more than one Optane
which drive to be accelerated. Click Enable. Follow the on-screen instructions to proceed. When completed,
restart the system.
5. Launch the Intel
Rapid Storage Technology utility from the Start menu and make sure the Intel
®
Memory has been enabled. If you want to accelerate the system drive, you can select specific folders, files,
or applications to accelerate using the Intel
used must have at least 32 GB capacity.)
• An Optane
memory cannot be used to accelerate an M.2 PCIe SSD.
™
• Do not abruptly remove the Optane
functioning correctly.
• If you want to change/remove the Optane
Storage Technology or Intel(R) Optane
• After enabling the Optane
Rapid Storage Technology utility from the Start menu, and
®
Memory on the Intel
Optane
®
memory, please select which one you are going to use. Then select
™
Optane
Memory Pinning function. (The Optane
®
™
memory. Doing so will cause the operating system to stop
™
memory, you must disable it using the Intel
™
Memory application first.
™
memory, the related BIOS settings will remain even after a BIOS update.
™
- 42 -
Memory screen.
™
memory installed
™
Optane
®
™
memory
™
Rapid
®
Advertisement
Table of Contents
