Table of Contents
Advertisement
& Power On By Mouse
Allows the system to be turned on by a PS/2 mouse wake-up event.
Note: To use this function, you need an ATX power supply providing at least 1A on the +5VSB lead.
Disables this function. (Default)
Disabled
Move the mouse to turn on the system.
Move
Double Click
Double click on left button on the mouse to turn on the system.
& ErP
Determines whether to let the system consume least power in S5 (shutdown) state. (Default: Disabled)
Note: When this item is set to Enabled, the following functions will become unavailable: Resume by Alarm,
power on by mouse, and power on by keyboard.
& Soft-Off by PWR-BTTN
Configures the way to turn off the computer in MS-DOS mode using the power button.
Press the power button and then the system will be turned off instantly. (Default)
Instant-Off
Delay 4 Sec.
Press and hold the power button for 4 seconds to turn off the system. If the power
button is pressed for less than 4 seconds, the system will enter suspend mode.
& Resume by Alarm
Determines whether to power on the system at a desired time. (Default: Disabled)
If enabled, set the date and time as following:
Wake up day: Turn on the system at a specific time on each day or on a specific day in a month.
Wake up hour/minute/second: Set the time at which the system will be powered on automatically.
Note: When using this function, avoid inadequate shutdown from the operating system or removal of the
AC power, or the settings may not be effective.
& Power Loading
Enables or disables dummy load. When the power supply is at low load, a self-protection will activate causing
it to shutdown or fail. If this occurs, please set to Enabled. Auto lets the BIOS automatically configure this
setting. (Default: Auto)
& CEC 2019 Ready
Allows you to select whether to allow the system to adjust power consumption when it is in shutdown, idle,
or standby state in order to comply with the CEC (California Energy Commission) 2019 Standards. (Default:
Disabled)
& RC6(Render Standby)
Allows you to determine whether to let the onboard graphics enter standby mode to decrease power
consumption. (Default: Enabled)
ƒ IO Ports
& Initial Display Output
Specifies the first initiation of the monitor display from the installed PCI Express graphics card or the onboard
graphics.
Sets the onboard graphics as the first display.
(Note)
IGFX
Sets the graphics card on the PCIEX16 slot as the first display. (Default)
PCIe 1 Slot
Sets the graphics card on the PCIEX4_1 slot as the first display.
PCIe 2 Slot
Sets the graphics card on the PCIEX4_2 slot as the first display.
PCIe 3 Slot
& Internal Graphics
Enables or disables the onboard graphics function. (Default: Auto)
& DVMT Pre-Allocated
Allows you to set the onboard graphics memory size. Options are: 32M~512M. (Default: 64M)
(Note) This item is present only when you install a CPU that supports this feature.
- 29 -
Advertisement
Table of Contents
