Point The Trunk Group To An Area Of The Ddi Table - NEC XN120 Manual

Point the Trunk Group to an Area of the DDI Table.

There are 2000 entries available within the DDI table.
At default the table is split into 10 areas and trunk group 1 is routed to area 1 for all 8 night modes as shown
below:
Trunk Night
Group Modes
1 1-8
You can leave this at default if you wish, you will need to make changes if you want different DDI routing for
each night mode in use by the customer.
For example, during day mode the main DDI number routes to reception but in night mode the same DDI
number must route to voice mail.
Program 22-13-01
Point the trunk group to an
area of the DDI table.
You can point to a different
area for each of the 8 night
modes.
XN120 Voice Over IP Card Guide
Area
DDI Entries
Number
1 1-200
2 201-400
3 401-600
4 601-800
5 801-1000
6 1001-1200
7 1201-1400
8 1401-1600
9 1601-1800
10 1801-2000
Ø Select the correct trunk group number with the Vol.
Ø Enter the DDI area number for each night mode.
Ø Press HOLD to confirm the entry and step to the next night
mode.
Ø When you have changed all 8 night modes the next trunk group
number will be displayed.
Ø Press DC several times when you are done to return to the
Program Mode.
(Press SPK to save changes and exit if you are finished).
Configure Incoming Calls
22-13-01 TrkGrp 1
Mode1 =1
Press Vol p q
to select the
trunk group
number
keys.
p q
21