Table of Contents
Advertisement
Chapter4 Applying Modification to the Sensor Driver Manually which is Installed by Using Archive version
Applying Modification to the Sensor
4.1
Driver Installed in Windows XP / Vista /
7 Environments Manually
This section describes how to apply modification to the Sensor driver installed in
Windows XP / Vista / 7 environments by using Archive version manually.
If a modification is applied manually
!Caution
Note that device information of the Sensor driver including the version
level information displayed in Device Manager is not updated.
For information how to check version level information of the Sensor
>See>
driver, refer to the "System Development Guide".
O
p
e
r
a
t
O
p
e
r
a
t
Ensure that the Sensor is not connected to the target hardware.
Step1
★Tip
Log in as Administrator.
Step2
Extract the downloaded archive version and copy the following files
Step3
from the folder created by the extraction to the hardware where the
Sensor driver is installed to overwrite the existing files.
The copy files and the folders to which the files copied are below.
fdpvusb.inf
fdpvusb.sys
fpvbusb.dll
fpvwrp.dll
i
o
n
i
o
n
When you cannot take off the Sensor
Ensure that the Sensor is out of use.
Copy File
Windows (x86) Environment
WINDOWS\inf system32\
WINDOWS\system32\drivers\
WINDOWS\
Folder to which file is copied
―
38
Windows (x64) Environment
WINDOWS\system32\
―
WINDOWS\system32\
WINDOWS\system32\
Hide quick links:
Advertisement
Table of Contents
