Set Programme - Asko T781 Manual

because the lower water magazine is full, due to
the pump or hoses being clogged or malfunctio-
ning. If condensation water is pumped out di-
rect to the drain, check to ensure there are no
kinks or stoppage in the hose. If this does not
help, phone for service.
Sensor fault. Fault in the moisture sensor. This
error message can also appear if you should start
the dryer when it contains dry items or when it
is empty. To cancel the message, simply open
the dryer door. If this does not work, phone for
service.
Thermistor fault. Phone for service.
WRONG LANGUAGE ON THE DISPLAY
If the language on the display becomes altered
for any reason, it can be restored to the initial
language again.
The available languages are Dansk, Deutsch,
English, Espanol, Français, Italiano, Nederlands,
Norsk, Portugués, Suomi and Svenska.
Proceed as follows to change the language:
Turn the main power switch,
then turn it on again. Press the
times, then press the
These ten times must be completed within fif-
teen seconds.
Within three seconds after pressing
last time, step to the desired language using the
, of and
button five
Enter
button five times.
P1
the
P1
buttons.
RESET PROGRAMME
If you wish to revert to the settings which a pre-
set programme had at the time when the dryer
was supplied, you can reset the programme.
Proceed as follows:
1. Hold down the programme button for the
programme that you wish to reset.
2. Press the button once.
Enter
3. Release the programme button.
The programme for the button is now reset
to its settings when the dryer was supplied.
STOP FLASHES IN THE DISPLAY
Start Stop
The programme has stopped temporarily be-
cause the door has been opened, the main po-
wer switch has been turned off or the power
supply has been interrupted.
To restart: Press the
To interrupt the programme completely:
Press the button for three seconds.
button.
27