Table of Contents
Advertisement
C010 - This unit weighs approximately 121.2lb (55kg). IBM recommends the use of
an appropriate lifting device to position the chassis on the rails.
Figure 9. Enclosure
5. Tilt and lower the enclosure; then, push the slides toward the enclosure
and make sure the farthest nailheads go into the slots on the slides.
Figure 10
6. Slowly lower the enclosure down and make sure the other 3 nailheads
slip into the slots.
Attention: You can only install the enclosure successfully when the slides
are fully extended.
Figure 10. Enclosure installation
Slide the enclosure into the rack
About this task
© Copyright IBM Corporation 2019, 2020, 2021.
Customer Install Guide, 2U Chassis
27
Advertisement
Table of Contents
