Table of Contents
Advertisement
If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated Screws (7) from the back
of the Console Base (98).
2. While a second person holds the Console (13),
connect the wire on the receiver to the indicated
wire extending from the Console. Next, hold the
receiver so the antenna is oriented as shown
and is facing away from the Console. Attach
the receiver to the Console in the location shown
with the two included small screws.
3. Make sure that no wires are pinched. See
drawing 1. Reattach the Console (13) to the
Console Base (98) with the Screws (7). Discard
the other wires included with the receiver.
1
7
7
7
2
Wires
Antenna
9
13
98
7
7
7
7
13
Receiver
98
Small
Screws
Advertisement
Table of Contents
