Checking Power Steering Fluid; Checking Tire Inflation Pressure - Toyota Matrix 2008 Manual

Table of Contents

Advertisement

Checking power steering fluid

If cold
O.K.
Open
Close
If cold
add
Check the fluid level through the reser-
voir. If necessary, add automatic trans-
mission fluid DEXRONrII or III.
If the vehicle has been driven around 80
km/h (50 mph) for 20 minutes (a little
more in frigid temperatures), the fluid is
hot (60_C—80_C or 140_F—175_F). You
may also check the level when the fluid
is
cold
(about
room
temperature,
10_C—30_C or 50_F—85_F) if the engine
has not been run for about five hours.
280
Clean all dirt from the outside of the res-
If hot
ervoir tank and look at the fluid level. If
O.K.
the fluid is cold, the level should be in the
"COLD" range. Similarly, if it is hot, the
fluid level should be in the "HOT" range.
If the level is at the low side of either
range, add automatic transmission fluid
DEXRONrII or III to bring the level within
If hot
the range.
add
To remove the reservoir cap, turn it coun-
terclockwise and lift up. To reinstall it,
turn it clockwise. After replacing the reser-
voir cap, visually check the steering box
case, vane pump and hose connections
for leaks or damage.
CAUTION
The reservoir tank may be hot so be
careful not to burn yourself.
NOTICE
Avoid overfilling, or the power steer-
ing could be damaged.
'08 MATRIX_U (L/O 0706)
Checking tire inflation
pressure
2008 COROLLA MATRIX from Aug. '07 Prod. (OM12B26U)

Advertisement

Table of Contents
loading

Table of Contents