Table of Contents
Advertisement
1886
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Partially install two of the light kit screws
found in the
bag. It does not matter
which two screw holes you choose. Connect
the plugs from the upper and lower switch
housings. Make sure to line up the colored
markings on the connectors.
Note:
Fan style may vary.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
7
Ceiling Bracket
Assembling the Light Kit
2 of 6
Light Kit Screw
bag
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.
2 of 6
Light Kit Screw
bag
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
Installing the Globe
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan
Wiring
Turn the light kit counterclockwise until the light
kit screws are firmly situated in the narrow end
of the keyhole slots. Install the third screw and
tighten all three screws securely.
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the globe until it stops.
NOTE: Check to ensure
proper engagement.
Canopy
Blades
Light Kit Screw
bag
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
Light Kit Screw
bag
WARNING
WARNING
GLOBE FALL HAZARD
To prevent SERIOUS INJURY, make sure that
globe is properly secured.
Light
Bulbs
1 of 6
1 of 6
Remote
Advertisement
Table of Contents
