Table of Contents
Advertisement
The lower right
display—The lower
right display can show
the speed of the walking
belt and the approxi-
mate number of calories
that you have burned.
The priority display—
The upper display is the
priority display. The pri-
ority display can show
the elapsed time, the
distance that you have
walked or run, the speed of the walking belt, or the
approximate number of calories you have burned.
Press the Display Mode button repeatedly until the
priority display shows the information that you are
most interested in viewing. Note: While information
is shown in the priority display, the same informa-
tion will not be shown in the lower left or right dis-
play.
To reset the displays, press the Stop button, re-
move the key, and then reinsert the key.
Note: The console can
display speed and dis-
tance in either miles
or kilometers. To see
which unit of mea-
surement is selected,
hold down the Stop button, insert the key into the
console, and then release the Stop button. An M
for metric kilometers or an E for English miles will
appear in the priority display. Press the Speed in-
crease button to change the unit of measurement.
When the desired unit of measurement is selected,
remove the key and then reinsert it.
5. Measure your heart rate if desired.
You can measure your heart rate using either the
thumb heart rate monitor or a compatible heart rate
monitor. For information about purchasing an
optional chest heart rate monitor, see
page 17.
The console is compatible with all BLUETOOTH
Smart heart rate monitors. To connect your heart
rate monitor to the console, see page 17.
Note: If you use both heart rate monitors at the
same time, the BLUETOOTH Smart heart rate
monitor will have priority.
To measure your heart rate, stand on the foot
rails and place your thumb on the pulse sensor
(see the drawing on page 13). Do not press too
hard, or the circulation in your thumb will be
restricted and your pulse may not be detected.
When your pulse is detected, a heart-shaped indi-
cator in the lower right display will flash each time
your heart beats, one or two dashes will appear,
and then your heart rate will be shown. For the
most accurate heart rate reading, hold your
thumb on the pulse sensor for at least 15
seconds.
If the displayed heart rate appears to be too high
or too low, or if your heart rate is not displayed, lift
your thumb for a few seconds, and then reposition
your thumb on the pulse sensor. Remember to
stand still while measuring your heart rate.
6. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button,
remove the key from the console, and put it in a
secure place. When you are finished using the
treadmill, press the power switch into the off posi-
tion and unplug the power cord. IMPORTANT: If
you do not do this, the treadmill's electrical
components may wear prematurely.
15
®
Advertisement
Table of Contents
