Tuning To A Station; Setting The Alarm Time - Philips AJ3720 Owner's Manual

RADIO

TUNING TO A STATION

MANUAL tuning
This is useful if you know the radio frequency of the station.
1. Press the TUNING / ∞ or § control briefly until you find the
desired station.
AUTOMATIC tuning
1. Keep TUNING / ∞ or § pressed until the display frequency
starts to run and then release.
– The display will show Srch.
2. When a station has been found, tuning will stop, or you can
stop the automatic tuning by pressing the TUNING / ∞ or §
control again. Repeat until you have found the desired station.
Preset stations
Storing preset stations
You can programme up to five stations from one or more bands.
You can also replace a preset station with another frequency. The
preset number of the station selected will be indicated in the
display.
1. Select and press a preset button 1 to 5.
2. Follow steps 1 to 4 under RADIO RECEPTION and tune to the
station either manually or automatically.
3. Press the SET button to confirm the preset number and
station while the display shows the desired frequency.
™ The preset number indication will blink once.
Selecting preset stations
• Select and press a preset button (1 -5) to recall the
corresponding frequency and waveband stored.

SETTING THE ALARM TIME

General
Two different alarm times can be set in a variety of modes. This
can be useful when for example you need to be woken up at a
different time during the week or at the weekend.
Note: To set the alarm, complete each step within 10 seconds.
Setting alarm 1 or 2
1. Press the ALARM 1 or 2 button.
™ The alarm time appears in the display
10
ALARM
AJ3720 PLL D
P1 P2 P3 P4 P5
VOLUME
ALM 1
AM
5
FM
MHz
ALM 2