Installation; Power Connection - Philips AJ3720 Owner's Manual

Philips aj3720: user guide
Hide thumbs Also See for AJ3720:
Table of Contents

Advertisement

Available languages

Available languages

CONTROLS
TOP, FRONT and SIDE PANEL
1 REPEAT ALARM/
TIME DATE
– To switch off the alarm for a 9 minute
period.
– To display/adjust the date (month and day)
and the year
– To resume clock time display
2 DISPLAY: To show the status of the set
3 PRESET 1-5:
– To select a preset radio station
– To select a preset radio alarm
4 ALARM RESET/RADIO OFF:
– To stop the active alarm for 24 hours
– To switch off alarm 1 or 2 completely
– To switch off the radio
5 SLUMBER/BUZZER
– To adjust the slumber time on/off
– To select the buzzer mode for alarm 1 or 2
6 RADIO ON
– To switch on the radio
– To go to radio display for 10 seconds
– To select the radio mode for alarm 1 or 2
7 BAND: To select the waveband

POWER CONNECTION

1. Check if the power voltage as shown on the type plate (on the
bottom of the set) corresponds to your local power voltage. If
it does not, consult your dealer or service organisation.
™ If your set is equipped with a voltage selector, found on the
bottom right-hand corner of the set, adjust the selector to
correspond with your local power.
2. Connect the power plug to the wall outlet.
– The AC power supply is now switched on and the numbers
on the display will start to flash. You will need to set the
correct time.
3. To switch off the AC power supply completely, pull the power
plug out of the wall outlet.
6
8 ALARM 1:To set, review or switch off alarm 1
:
9 VOLUME: To adjust the radio sound level
0 TUNING / ∞ or § (up or down)
– To tune to radio stations automatically or
– To adjust the clock time, alarm time, date,
! p: 3.5 mm headphone jack
@ WEEKEND SLEEPER
– To activate or deactivate the weekend
# SET:
– To confirm preset stations stored
– To activate the setting mode for clock time
$ BRIGHTNESS CONTROL: To change the
% Pigtail: For FM reception
^ MAINS: for connecting the set to the power

INSTALLATION

ALARM 2: To set, review or switch off alarm 2
manually
year
sleeper for alarm 1 or 2
brightness of the display illumination
supply
SUN MON TUE WED THUR FRI SAT
ALM 1
AM
Z Z
PM
SLUMBER
ALM 2
MW
FM
MHz
Z Z
kHz
P1 P2 P3 P4 P5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aj3720/17bAj3720/17Aj 3720

Table of Contents