Table of Contents
Advertisement
Adjusting the level of [EVF/LCD DETAIL]
1
Select the menu.
MENU
: [DISP SETUP] # [EVF/LCD PEAK LEVEL]
2
Touch
/
≥ You can select a value between s3 and r3.
3
Touch [EXIT] to complete the setting.
Setting the peaking frequency of [EVF/LCD DETAIL]
Select the menu.
MENU
: [DISP SETUP] # [EVF/LCD PEAK FREQ.] # [HIGH] or [LOW]
≥ [EVF/LCD DETAIL] is canceled in following cases:
j When Focus Assist (peaking function) is used
One Push AF
If you press the USER button to which [PUSH AF] is registered in Manual Focus Mode, the camera
performs high-speed focusing until the image is focused.
≥ Switch to Manual Focus Mode.
Press the USER button to which [PUSH AF] is registered or touch the applicable
USER button icon.
≥ Auto Focus will be activated and the camera will perform high-speed focusing until the image is
focused.
≥ The focus setting returns to Manual Focus Mode once the image is focused or a certain time has
elapsed.
≥ One Push AF does not work in following cases:
j When Auto Focus is used
Push AF
If you press and hold the USER button to which [PUSH AF] is registered, Manual Focus will be
temporarily switched to Auto Focus.
≥ Set this unit to Manual Focus.
Press and hold the USER button to which [PUSH AF] is registered or touch and
hold the applicable USER button icon.
≥ The focus position will be automatically adjusted for the subject at the center of the screen.
≥ If you set [AREA MODE] to [FOCUS], [FOCUS/IRIS] or [FOCUS/Y GET] and use Area Mode, the
focus position will be automatically adjusted to the subject you have touched.
≥ It will be canceled when the button is released, and the focus position set by the Push AF will be
maintained.
≥ Push AF does not work in following cases:
j When Auto Focus is used
to adjust settings.
(l
44)
(l
44)
(l
46)
- 45 -
(l
69)
Advertisement
Table of Contents
