Installing Mux/Demux And 2.5 Gbps Transponder Modules; Installing The Extended Range Transponder Modules With Sfp Optics - Cisco ONS 15540 ESP Hardware Installation Manual

Chapter 2 Installing the Cisco ONS 15540
Step 7
Step 8
Step 9

Installing Mux/Demux and 2.5 Gbps Transponder Modules

Step 1
Step 2
Step 3
Step 4
Installing the Extended Range Transponder Modules with SFP
Optics
Note
78-15095-01
Insert the 16-channel mux/demux module without OSC carefully into the bottom
motherboard slot while guiding the upper and lower edges of the module in the
tracks until its connectors come into contact with the backplane connectors. You
hear a click when it is connected.
Attach the OSC cables and all other appropriate cables. The connections on the
16-channel mux/demux modules are one-to-one.
Check the LEDs to ensure proper installation. See
LED descriptions.
To install the mux/demux modules or 2.5 transponder modules follow these steps:
Remove the failed module or the filler module from the motherboard.
Take a new module from the shipping container.
Insert the module carefully into the motherboard slot while guiding the upper and
lower edges of the module in the tracks until its connectors come into contact with
the backplane connectors. You hear a click when it is connected.
Attach the appropriate cables.
Save the filler modules with the packaging material.
Only use Cisco-certified SFP optics for the extended range transponders.
Cisco ONS 15540 ESP Hardware Installation Guide
Installing and Removing Modules
Table 1-7 on page 1-17 for
2-19