Table of Contents
Advertisement
The following parameters can be configured:
Parameter
Description
Interface Name
Displays the interface being edited.
VLAN Name
Enter the name of the VLAN corresponding to the interface. (System interface only)
Enter an alternative IPv4 address. Currently an interface can only have one IPv4 address defined.
Therefore multinetting configuration of IPv4 must be done through creation of a secondary
IPv4 Address
interface on the same VLAN, instead of directly configuring multiple IPv4 addresses on the same
interface.
Subnet Mask
Enter the corresponding subnet mask.
IPv4 State
This function allows user to enable the IPv4 address on the IP interface.
Click Apply to implement changes made.
To edit an entry for IPv6 features click the corresponding IPv6 Edit button.
The following parameters can be configured:
Parameter
Interface Name
VLAN Name
IPv6 Network
Address
IPv6 State
NS Retransmit time
(0-4294967295)
Automatic Link
Local Address
Click Apply to implement changes made.
DAS-3626 VDSL2 Switch User Manual
Figure 17. IPv6 Interface Settings Edit menu
Description
Displays the interface being edited.
Enter the name of the VLAN corresponding to the interface. (System interface only)
Enter the IPv6 Network Address to be configured. The interface can have multiple IPv6
addresses defined. Configuration of IPv6 addresses must be done through the command
config ipif.
Allows the user to enable or disable the IPv6 state on the interface.
This field is used to set the interval, in milliseconds that the switch will produce neighbor
solicitation packets to be sent out over the local network. This is used to discover IPv6
neighbors on the local network. The user may select a time between 0 and 4294967295
milliseconds. The default is 0.
Enables or disables the automatic configuration of link local addresses when there are no
IPv6 addresses explicitly configured. When an IPv6 address is explicitly configured, the link
local address will be automatically configured, and the IPv6 processing will be started. When
there is no IPv6 address explicitly configured, by default, link local address is not configured
and the IPv6 processing will be disabled. By enabling this automatic configuration, the link
local address will be automatically configured and IPv6 processing will be started.
16
Advertisement
Table of Contents
