Lincoln Electric CV 510 Operator's Manual page 10

Output Connections
Refer to points [4], [5], [6] and [8] of the Figures 2.
Controls and Operational Features
3
2
1
4
5
Figure 2.
1. Power Switch ON/OFF (I/O): Controls the input
power to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I").
2. Power Indicator Light: After input power
is connected and the power switch is
turned on, this lamp will light up to
indicate the machine is ready to weld.
3. Thermal Overload Indicator: This lamp
will light up when the machine is
overheated and the output has been
turned off. This can occur if the ambient
temperature is above 40°C or the duty cycle of the
machine has been exceeded. Leave the machine on
to allow the internal components to cool, when the
lamp turns off normal operation is possible.
4. Low Inductance Negative Output Socket:
For connecting a work lead.
5. High Inductance
Socket: For connecting a work lead.
6. Wire Feeder
receptacle for wire feeder. Provides
connections for auxiliary power of wire
feeder.
7. Wire Feeder Voltmeter Switch: This
switch selects the polarity of the wire
feeder voltmeter, if so equipped. When the welding
torch is positive (MIG, Outershield and some
Innershield processes), set the switch to "+". When
the welding torch is negative (most Innershield
applications), set the switch to "-".
8. Positive Output Socket: Allows the
connection, with the power cable, to the
wire feeder.
English
9
7
6
8
Negative Output
Receptacle: 14-pins
9. Digital Welding Current and Voltage Meter: Available
as an option (see "Accessories" chapter – Kit
K14082-1).
10. Fuse: Use the 6,3A slow-blow fuse (see "Spare
Parts" section).
11. Hole Plug: For CO
"Accessories" chapter - K14009-1 CO
12. Cooler Power Supply Socket: For supplying the
cooler unit only.
The socket has an output of 230V, 2.5A and is protected
by the circuit breaker [13].
13. Circuit Breaker: Protects the Cooler
Power Supply socket [12]. It shuts off the
power supply when the current exceeds
2.5A. Press it to restore the power
supply.
14. Power Lead (5m): Connect the supply plug to the
existing input cable that is rated for the machine as
indicated in this manual, and conforms to all
applicable standards. This connection shall be
performed only by a qualified person.
11
11
8
gas heater socket (see
2
Socket Kit).
2
WARNING
CV 425
10
12
13
14
CV 510
10
12
13
14
Figure 3.
English