Heat Sink; Removing The Heat Sink - Dell OptiPlex All-in-One Plus 7410 Owner's Manual

Steps
1. Insert the speakers into their slots on the display-assembly base.
2. Route the speaker cable through the routing guides on the display-assembly base.
3. Connect the speaker cable (INT SPKR) to the audio board.
Next steps
1. Install the bottom cover.
2. Install the I/O cover.
3. Install the system-board
4. Install the back cover.
5. Install the stand.
6. Follow the procedure in

Heat sink

Removing the heat sink

Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the back cover.
4. Remove the system-board
About this task
NOTE: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
NOTE: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
shield.
After working inside your
Before working inside your
shield.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs) 85