Removing The M.2 2280 Solid-State Drive In M.2 Slot 0 - Dell OptiPlex All-in-One Plus 7410 Owner's Manual

About this task
NOTE: This procedure is only applicable if you are installing an M.2 2230 solid-state drive into the solid-state drive slot (M.2
PCIe SSD 0) on the system board.
NOTE: Ensure that the M.2 screw mount is in the proper location to install the M.2 2230 solid-state drive, refer to
of the screw mount on M.2 slot
The following image(s) indicate the location of the M.2 2230 solid-state drive in M.2 slot 0 and provides a visual representation
of the installation procedure.
Steps
1. Align the notch on the M.2 2230 solid-state drive with the tab on the solid-state drive slot (M.2 PCIe SSD 0).
2. Slide the M.2 2230 solid-state drive into the solid-state drive slot (M.2 PCIe SSD 0) on the system board.
3. Replace the screw (M2x3.5) that secures the M.2 2230 solid-state drive to the system board.
Next steps
1. Install the system-board
2. Install the back cover.
3. Install the stand.
4. Follow the procedure in

Removing the M.2 2280 solid-state drive in M.2 slot 0

Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the back cover.
4. Remove the system-board
About this task
NOTE: Depending on the configuration ordered, your computer may have up to two M.2 2230 or 2280 solid-state drives
installed in the solid-state drive slots on the system board.
0.
shield.
After working inside your
Before working inside your
shield.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
Location
55