Table of Contents
Advertisement
10.
Install the drain plug when the hydraulic fluid
stops draining.
11.
Install the reservoir dipstick and cap.
12.
Start the engine and use all of the hydraulic
controls in the following order to distribute
hydraulic fluid throughout the system:
A.
Use the traction pedal to move the machine
forward and backward.
B.
Use the steering wheel to move the tires all
the way to the right and left.
C.
Use the lift switch to raise and lower the
attachment (e.g., cutting unit).
13.
Check for leaks and shut off the engine.
14.
Check the hydraulic fluid level in the tank; refer
to
Checking the Hydraulic-Fluid Level (page
Checking the Hydraulic
Lines and Hoses
Service Interval: Every 2 years
Inspect the hydraulic lines and hoses daily for
leaks, kinked lines, loose mounting supports, wear,
loose fittings, weather deterioration, and chemical
deterioration. Make all necessary repairs before
operating the machine.
Cab Maintenance
Cleaning the Cab
Important:
Use care around the cab seals
82). If you are using a pressure washer, keep the
washer wand at least 0.6 m (2 ft) away from the
machine. Do not use the pressure washer directly
on the cab seals or under the rear overhang.
65).
1. Seal
2. Keep wand 0.6 m (2 ft)
away.
Cleaning the Cab Air Filters
Service Interval: Every 400 hours
1.
Remove the knobs and grates from the cab rear
overhang
67
Figure 82
3. Do not pressure wash
under the rear overhang.
(Figure
83).
(Figure
g303806
Advertisement
Table of Contents
