KTM 125 EXC 2016 Owner's Manual page 63

12 SERVICE WORK ON THE CHASSIS
(Six Days)
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether upper steering head seal
–
Mount protective ring
B01218-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the clutch line and wiring harness.
602736-10
–
Position the fork legs.
602737-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
602738-10
–
Tighten screw
Guideline
Screw, top steering head
602739-10
p. 143)
 and O-ring

but do not tighten yet.
Info
The rebound damping is located in right fork leg REB (red adjusting
screw). The compression damping is located in left fork leg COMP (white
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.

Position bleeder screws

.

.

is correctly positioned.
 .
toward the front.
M8 15 Nm
(11.1 lbf ft)
M20x1.5 12 Nm
(8.9 lbf ft)
61